Designed to be embedded in concrete to provide a means of suspending pipe from ceilings. The insert is held in place by nailing it to the forms, until the concrete is poured. The insert comes with a snap-out plug to keep the inner housing clean during pouring of the concrete. After the concrete has set, the plug is removed, exposing the inner housing. The rod should be tightened until it touches the top of the insert, but should not be forced further to avoid damage to the insert.
PHD Insert Nut, Series: FIG 951N, Carbon Steel, Electro-Galvanized, 1/2 in THK x 1-1/4 in L x 1-1/4 in W
Dimensions
1/2 in THK x 1-1/4 in L x 1-1/4 in W
Finish
Electro-Galvanized
Material
Carbon Steel
Series
FIG 951N
- Maximum recommended load 600 lb
- 3/4 in rod
- Low carbon steel