Check Valves are automatic shut-off valves that are commonly used for preventing backflow or drainage in a piping system. Often applied on the discharge side of pumps, check valves prevent the system from draining if the pump stops and protect against backflow, which could harm the pump or other equipment.
Titan® Swing Check Valve, Single Disc Wafer, Series: CV32-CS, 6 in Nominal, Flanged End Style, 285 psi WOG Pressure, 150 lb Pressure Class, 100 deg F, No Low Lead Compliance, 3-3/4 in Inlet to Outlet Length, Carbon Steel Body, 316 Stainless Steel Trim, FKM Softgoods, Epoxy Painted, 8-5/8 in Dia
Body Material
Carbon Steel
Dimensions
8-5/8 in Dia
End Style
Flanged
Finish
Epoxy Painted
Inlet to Outlet Length
3-3/4 in
Low Lead Compliance
No
Nominal Size
6 in
Pressure Class
150 lb
Pressure Rating
285 psi WOG
Series
CV32-CS
Softgoods Material
FKM
Temperature Rating
100 deg F
Trim Material
316 Stainless Steel
Type
Single Disc Wafer
- Economical design - Low weight and short laying length produce savings in initial cost, space requirements and installation when compared to full body, swing type check valves
- Minimal head loss - Head loss is minimized by providing a short, straight and virtually unobstructed flow path
- Additionally, the spring loaded disc is designed with very low cracking pressure which reduces the amount of energy required to open the valve
- Quick closure to reduce water hammer - Shut-off is achieved via the fully automatic, spring assisted disc that closes near zero flow velocity
- The lightweight, single disc design creates a positive shut-off prior to flow reversal which helps to keep surges to a minimum
- Feature anti-corrosive, stainless steel trim (disc, spring, shaft) as standard
- Resilient soft seats (FKM and PTFE O-ring) coupled with precision machined sealing surfaces help to ensure a bubble tight seal that meets or exceeds API 598 test requirements
- FKM O-ring